Living Crafts Mold & Mildew Stain Remover

Sodium Hypochlorite (cleaning, less than 5%), Acidity Regulator (washing aid, less than 5%)

1 Bottle (344g)

16 August 2023

STEP 1 - Dry the area to be used. (If there is moisture, it may be less effective.)

STEP 2 - Open the lid and apply it to the molded tiles and the silicone area.

STEP 3 - After 3 to 5 hours, rinse thoroughly with water. (If the molded area is wide or deep, it is recommended to increase
the amount used or lengthen the leaving time.)

STEP 4 - If the stain is not completely removed, repeat again, or gently scrub with a scrubber or brush.
* Disinfecting and cleaning the inside of the toilet: Apply gel evenly to the inside of the toilet, then scrub with a brush and rinse thoroughly.
* General bathroom cleaning: Squeeze the product 2-4 times in 5L of water, apply the diluted solution to a sponge, brush, etc., then rinse thoroughly.

1. Do not use other than product purpose.

2. When using, be sufficiently ventilated and wear rubber gloves.

3. Close the lid after use and store in a cool place out of reach of children.

4. Wash with water in case of contact with skin or eyes.

5. If you drink, drink water and vomit immediately and consult a doctor.

6. Be careful as it may discolor if it gets on clothing.

7. Discoloration or parts contaminated with metallic components (yellow silicon) may be ineffective.

8. The mold removal effect may vary depending on the degree of contamination.

9. Freezing or exposure to sunlight or heat during storage may cause viscosity to thin.